Features and Specs for the Auluminator
- 2 ply belt flaps full width of trailer floor
- Bolt on 5th wheel plate
- Hydraulic Gear drive 130,000 in-lb, 18,000 pound radial load
- 2 15/16" rear drive shaft, with weld on sprockets and weld on splined hub
- Top hinge hydraulic main gate, with center knife gate and cylinder locks, 12"
- clearance above top rail
- Floor liner is 3/8" thick UHMW plastic
- Sides fully lined with 3/16" HMW plastic all the way to the top
- Extended rear discharge with wings on rear of trailer
- Hydraulic pressure line filter, manual or electric control valve
- Hydraulic floor speed control
- Side and slope sheets are post and hat riveted aluminum construction
- 50,000 lb landing gear
- ABS brake system
- 11 x 22.5 on 10 bolt hub pilot aluminum rims
- Hendrickson Intraax Air ride suspension with 25,000 lb axles
- Various axle combinations available
- Shur-Loc roll tarp
- D.O.T. lighting, Reflective tape
- Other custom options available - Just ask!!